Control Panel Assembly; Removing The Control Panel Assembly - Dell PowerEdge T630 Owner's Manual
Hide thumbs
Also See for PowerEdge T630:
- Owner's manual (176 pages) ,
- Getting started (2 pages) ,
- Owner's manual (221 pages)
Table of Contents
Advertisement
Figure 61. Removing and installing the SD vFlash media card
1.
SD vFlash media card
3.
To install an SD vFlash media card, with the label side facing up, insert the contact-pin end of the SD
vFlash media card into the card slot on the module.
NOTE: The slot is keyed to ensure correct insertion of the card.
4.
Press the card inward to lock it into the slot.
Control panel assembly
Removing the control panel assembly
Prerequisites
1.
Ensure that you read the
2.
Keep the #2 Phillips screwdriver ready.
3.
Follow the procedure listed in
4.
If applicable, remove the cooling fan assembly.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Steps
1.
Remove the screw securing the control panel to the chassis.
2.
Disconnect the control panel cable and the control panel USB cable from the system board.
CAUTION: Do not use excessive force when removing the control panel cables as it can
damage the connectors.
3.
Slide the control panel out of the chassis.
4.
Disconnect the cables from the control panel.
Safety
instructions.
Before working inside your
2.
SD vFlash media card slot
system.
133
Advertisement
Table of Contents
Troubleshooting
