Caster Wheels (Optional)-Tower Mode; Installing Caster Wheels - Dell PowerEdge T630 Owner's Manual
Hide thumbs
Also See for PowerEdge T630:
- Owner's manual (176 pages) ,
- Getting started (2 pages) ,
- Owner's manual (221 pages)
Table of Contents
Advertisement
Steps
1.
Align the three tabs on the system feet with the three slots on the base of the chassis.
2.
Secure the system feet to the base of the chassis by using the screws.
Next steps
Place the system upright on a flat, stable surface, and turn the system feet outward.
Caster wheels (optional)—tower mode
Caster wheels provide mobility to the system in the tower mode.
The caster wheel assembly consists of:
•
Caster wheel units (front and back)
•
Two screws for the caster wheel units
Installing caster wheels
Prerequisites
1.
Ensure that you read the
2.
Keep the #2 Phillips screwdriver ready.
3.
Lay the system on its side on a flat, stable surface with the base of the system extending off the edge
of the surface.
4.
If installed, remove the system feet. For more information, see
Steps
1.
Align the two retention hooks on the back wheel unit with the two slots on the base of the chassis,
and insert the hooks into the slots.
2.
Offset the back wheel slightly to the back of the system and secure the unit in place using a single
screw.
3.
Align the two retention hooks on the front wheel with the two slots on the base of the chassis, and
insert the hooks into the slots.
4.
Offset the front wheel slightly to the front and secure the unit in place using a screw.
Safety
instructions.
Removing the system
feet.
49
Advertisement
Table of Contents
Troubleshooting
