Table of Contents
Advertisement
The following problems do not always denote a defective VCR.
Therefore, perform the checks described below before calling for service.
Problem
No power. Operate
Make sure the AC power cord is properly
l
l
indicator does not light.
plugged into the wall socket and the AC
Tape cannot be ejected.
power cord socket on the rear of the VCR.
l
Check the AC outlet, fuse or circuit breaker.
l
Turn on power.
l
Press the TIMER ON/OFF button to
l
disengage the timer.
VCR does not operate
Dew inside. Wait until the DEW indicator on
l
l
even if Operate indicator
the VCR display goes out.
is lit.
Press the EJECT button several times.
l
Safety device in VCR is functioning. Unplug
l
VCR and plug in again after about one
minute.
VCR does not record.
Cassette erasure protection tab has been
l
l
removed. Use a different cassette or place
adhesive tape over the tab opening.
Check if a cassette is loaded.
l
Cassette erasure protection tab has been
Cassette is automati-
l
l
c a l l y e j e c t e d w h e n
removed. Use a different cassette or place
pressing REC, m0 or
adhesive tape over the tab opening.
TIMER ON/OFF button.
No colour or poor TV
Make sure all the cables are correctly
l
l
picture.
connected.
No tape movement.
Make sure the VCR is not in pause/still mode.
l
l
Make sure the tape has not reached the
l
beginning or end.
Press the TRACKING buttons or try a different
Snowy picture appears
l
l
on TV during playback.
cassette.
The heads may be contaminated with
l
condensed moisture or magnetic coating from
the video tape. (If this is the case, the heads
need to be cleaned. Ask the retailer or a
Sharp approved service centre.)
No picture appears or
Make sure the TV is set to the same channel
l
l
colour is not correct
as the VCR radio frequency converter output
during playback.
channel adjuster (CHANNEL).
Suggested Solution
Problem
' C a s s e t t e c a n n o t b e
Make sure there is no other cassette inside.
l
loaded.
Make sure the cassette is correctly positioned
l
and then reinsert.
Make sure the VCR is not in the timer setting
l
even though CHANNEL
or clock setting mode.
Make sure the VCR is not in the channel
up/down buttons are
l
pressed.
setting mode (either "L", "H" or "U" is lit on the
VCR display).
Press the ALL CLEAR button and set the clock
l
not operate properly.
again. Set the timer again if necessary.
Make sure that the Child-Proof Lock is not
l
which button is pressed.
engaged.
The channel may have been set to be skipped.
l
cannot be selected.
Cancel the skip setting for that channel.
Make sure that BI is not displayed on the
l
remote control's LCD. If m is displayed, press
operated by the remote
control.
the VCR @ B4 button to select VCR mode.
Simulcast is on (When the channel display
l
mode is selected, "SI" is displayed on the
audio is not recorded, or
audio from a different
VCR). Press the SIMUL button to disengage
source is recorded.
the simulcast mode ("SI" turns off).
Suggested Solution
22
Advertisement
Table of Contents
