Installation
Technical data
– Delivery specification: dryer, instructions for installation and use, woollens basket
(depending on model).
– Check dryer for transport damage.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off.
– Do not set up in a room that is susceptible to frost.
Freezing water may cause damage.
– If in doubt, have the appliance connected by an expert.
Setting up the dryer
Take all accessory parts
1.
– The appliance plug must always be accessible.
out of the drum.
The drum must be empty.
– Ensure that the appliance is installed on a clean, level
and solid surface.
– Keep the cooling grille at the front of the dryer
Consumption values table
unobstructed.
– Keep the area around the dryer clean.
– Make the dryer level using the threaded feet
Programme
and a spirit level.
Do not remove the threaded feet under any
Cottons
circumstances.
Cupboard Dry*
Do not set up the dryer behind a door or sliding
door as this may obstruct or prevent the dryer door
Iron Dry*
from opening. This will prevent a potentially fatal
danger to children from locking themselves in.
Clean and level
Easy-Care
Cupboard Dry*
Make sure that the air
inlet remains unobstructed
*
Programme setting for testing in accordance with the applicable EN61121 standard.
Mains connection
** The values may differ from those specified, depending on the type of fabric, composition of laundry to be dried, residual moisture in the fabric and the
2.
see safety instructions
Page 11.
amount of laundry being loaded.
– Connect to an AC earthed socket. If in doubt have the socket checked by an expert.
– The mains voltage and the voltage shown on the rating plate (
Page 9) must correspond.
Most efficient programme for cotton fabrics
– The connected load and necessary fuse protection are specified on the rating plate.
The following "standard cottons programme" (identified with
its combined energy consumption for drying wet cotton laundry.
Do not operate the dryer if
Frost protection / Transport
Standard programme for cottons in accordance with current EU regulation 932/2012
there is a danger of frost.
Programme
Preparation
Cottons Cupboard Dry
1. Empty the condensate container
page 4.
Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU.
2. Select any programme using the programme selector.
3. Press the
Start/Stop button
condensation is pumped into the container.
Optional accessories
4. Wait 5 min., and then empty the condensate container again.
5. Turn the programme selector to Off.
WMZ
20500
WTZ
11310
WTZ
1110
WTZ
10290
8
7
What to do if ...
Dimensions (DxWxH)
60 x 60 x 85 cm (height adjustable)
If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales service. We will
Weight
approximately 45 kg
always find an appropriate solution and will avoid unnecessary visits by engineers. Trust the expertise of
the manufacturer and rest assured that the repair will be carried out by trained service technicians using
Max. capacity
7 kg
original spare parts. The contact details of your local after-sales service can be found in the enclosed
Condensate container
4.2 l
after-sales service directory, or by calling one of these numbers:
Connection voltage
– GB 0344 892 8979 (Calls charged at local or mobile rate.)
Connected load
– IE 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.)
When contacting the after-sales service, please quote the appliance's product number (E no.) and
Fuse protection
see appliance rating plate
production number (FD) (see the inside of the door).
Ambient temperature
Set the programme selector to Off and remove the appliance plug from the socket.
Product number/
The
Start/Stop indicator lamp
Production number
does not light up.
You can find the rating plate on the back of the dryer.
The display panel light and indicator
Power consumption when switched off
0.10 W
lights (depending on model) go out
Power consumption when ready for use (left-on mode)
1.00 W
and the
Start/Stop indicator light
Drum interior light (depending on model) (bulb E14, 25 W): The drum lights up after the door is opened or closed,
flashes.
and after the programme starts, and switches off automatically. Changing the bulb
page 10.
The Container and
indicator lights are flashing.
The Clean and
Spin speed which
indicator lights are flashing.
is used for spinning the
Duration**
Energy consumption**
laundry
Dryer does not start.
7 kg
3.5 kg
7 kg
3.5 kg
1400 rpm
106 min
65 min
3.60 kWh
1.97 kWh
1000 rpm
124 min
76 min
4.20 kWh
2.30 kWh
Water is running out.
800 rpm
143 min
88 min
4.80 kWh
2.63 kWh
1400 rpm
82 min
50 min
2.59 kWh
1.42 kWh
The door opens by itself.
1000 rpm
98 min
60 min
3.28 kWh
1.80 kWh
Creasing.
800 rpm
112 min
69 min
3.96 kWh
2.17 kWh
3.5 kg
3.5 kg
800 rpm
42 min
1.35 kWh
Laundry is not dried correctly or is
600 rpm
51 min
1.65 kWh
still too damp.
) is suitable for drying normal, wet cotton laundry and is most efficient in terms of
Load
Energy consumption
Programme duration
7 kg/3.5 kg
4.20 kWh/2.30 kWh
124 min/76min
Drying time too long.
(from after-sales service using order number, depending on model)
Platform
For easier loading and unloading. The basket contained in the drawer can be used to carry the laundry.
The humidity in the room increases
significantly.
Washer-dryer stack connection set
The dryer can be placed on top of a suitable washing machine with the same width and depth to save space.
Power failure.
The dryer must be fastened to the washing machine using this connection set. With pull-out worktop: WTZ 11300
Connection fittings for condensation outlet
One or more indicator lights for
The condensation is conveyed directly via a hose.
programme status are flashing.
Installation underneath the worktop
The interior light is not working
Instead of the appliance covering plate, you must have a metal cover fitted by a specialist.
(depending on model).
9
Safety instructions
Emergency
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
– in rooms inside the house.
dryer...
– to dry fabrics.
The dryer must
– be used for other purposes than those described above.
NEVER...
– be modified in terms of its technology or attributes.
Dangers
– The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
Mains plug plugged in? Programme selected?
– Keep pets away from the dryer.
Check the socket fuse.
– Remove all objects from pockets. Make especially sure that cigarette lighters
are removed as they constitute an
Energy-saving mode is activated
see the separate Energy-saving
– Do not lean or sit on the door
mode instructions.
Installation
– Secure loose cables
– Do not operate the dryer if there is a risk of frost.
Start/Stop
Empty the condensate container.
– Connect the dryer according to specifications to an AC earthed socket, as
Mains
If featured, check hose for condensation outlet.
connection
otherwise it cannot be guaranteed that the appliance is completely safe.
Start/Stop
Clean the fluff filter and/or air cooler under running water
– The cable cross-section must be sufficient.
Page 4/6.
– Only use earth-leakage circuit breakers with the following symbol:
Start/Stop button selected?
– The appliance plug and socket must be compatible.
Door closed?
– Do not use multiple plugs/couplings and/or extension cables.
Programme set?
– Do not hold the appliance plug with wet hands
Ambient temperature greater than 5°C?
– Never pull the appliance plug out of the socket by its cable.
Align dryer horizontally.
– Do not damage the mains lead
Clean air cooler seal.
Operation
– Only load the drum with laundry. Check the contents before you
Push the door closed until you hear it engage.
switch the dryer on.
Laundry load exceeded?
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
Remove articles of clothing immediately after the end of
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
the programme, hang up and pull into shape.
cleaning solvent, etc.)
Unsuitable programme selected
Page 7.
– The tumble dryer is not to be used if industrial chemicals have been used for
After the end of the programme, warm laundry feels damper than it
cleaning.
actually is. Spread the laundry out and allow the heat to disperse.
– Dust (e.g. coal dust, flour) poses a danger: do not use the dryer
Finely adjust the dryness level – this extends the drying time but
explosion hazard.
does not increase the temperature. Your laundry will become drier.
– Do not turn off the dryer until the drying process ends, unless the laundry will
Select a programme with a longer drying time or increase the
be removed quickly and spread out, so that the heat can dissipate.
drying level. This does not increase the temperature.
– Do not put laundry containing foamed material/rubber in the dryer
Select a time programme for extended drying of laundry that is still
elastic material may be destroyed and the dryer may be damaged due to
damp.
possible deformation of the foamed material.
If you have exceeded the maximum load for the programme, the
– Light things, such as long hair, may be sucked into the air inlet of the dryer
laundry may not be dried correctly.
Clean the moisture sensor in the drum. A fine layer of limescale
Risk of injury.
may adversely affect the performance of the sensors and your
– Final part of a tumble dryer cycle occurs without heat (cool down cycle), to
washing will not dry properly.
ensure that the items are left at a temperature that ensures that the items will
Drying has been interrupted as a result of a power cut, because the
not be damaged.
condensate container is full or because the maximum drying time
– Switch off the dryer once the programme has ended.
has been exceeded.
– Condensation is not drinking water and may be contaminated with fluff.
Rinse the fluff filters under running water
Page 4.
Defect
– Do not use the dryer if it is defective or if you suspect it is.
Insufficient supply of air
ensure that air can circulate.
Air inlet possibly blocked
Clear inlet
Page 8.
Repairs must only be carried out by the after-sales service.
Ambient temperature higher than 35 °C
ventilate the room.
– Do not use the dryer if the mains cable is defective. To avoid danger, only
have the defective mains cable replaced by the after-sales service.
Make sure the room is sufficiently ventilated.
– Always pull the mains plug out of the socket before changing the bulb for the
interior light
Remove laundry from the dryer immediately and spread out. This
allows the heat to dissipate. Be careful as the door, the drum and
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
the laundry may be hot.
Disposal
– Dryer: pull out the appliance plug, then cut off the mains cable from
Clean filter and air cooler
Page 4/6.
the appliance. Dispose of at municipal waste disposal facility.
Check installation conditions
Page 8.
– Packaging: do not leave children alone with packing parts
Switch off, leave to cool down, switch on again, restart programme.
risk of suffocation.
Pull out the appliance plug, remove the cover cap in the interior
– All materials are environmentally sound and can be reused.
above the door (use Torx 20 screw driver) and replace the bulb.
Dispose of in an environmentally-responsible manner.
Close the cover cap. Never operate the dryer without a cover cap.
10
explosion hazard.
risk of tipping.
tripping hazard.
risk of electric shock.
risk of electric shock.
fire/explosion hazard.
Dryer
WTE84106GB
risk of electric shock.
en Instruction manual
11