Most interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one connector matches a tab or a filled-in hole on the other

connector. Keyed connectors ensure that the pin-1 wire in the cable (indicated by the colored stripe along one edge of the IDE cable—serial ATA cables do not

use a colored stripe) goes to the pin-1 end of the connector. The pin-1 end of a connector on a board or a card is usually indicated by a silk-screened "1"

printed directly on the board or card.

NOTICE:

When you connect an IDE interface cable, do not place the colored stripe away from pin 1 of the connector. Reversing the cable

prevents the drive from operating and could damage the controller, the drive, or both.

Power Cable Connectors

IDE Drive Power Connector

1 power cable

2 power input connector

Connecting and Disconnecting Drive Cables

When removing an IDE drive data cable, grasp the colored pull-tab and pull until the connector detaches.

When connecting and disconnecting a serial ATA data cable, hold the cable by the black connector at each end.

Like IDE connectors, the serial ATA interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one connector matches a tab or a

filled-in hole on the other connector.

Hard Drive

CAUTION:

Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

Serial ATA Power

Connector

Table of Contents