Table of Contents
Advertisement
O N E - W A Y
A U T O M A T I C / M A N U A L
R E M O T E
S T A R T E R
W I T H
AS-6280 / AS-6280U
User Guide
It is the responsibility of the vehicle operator to ensure their vehicle
is parked in a safe and responsible manner.
1. a) Manual transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in "Park" in order to
avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is disabled
or put into valet mode before servicing.
Designed & engineered in Canada
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the
device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (EIRP) is not more than that required for successful
communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the equipment
Doc#: 120821
Rev:1.4
© 2012
T R A N S M I S S I O N
F U L L
A L A R M
S Y S T E M
WARNING
- AS-6280 -
- ME -
Canada
Advertisement
Table of Contents
Related Manuals for Auto Start AS-6280U
Summary of Contents for Auto Start AS-6280U
- Page 1 W I T H F U L L A L A R M S Y S T E M AS-6280 / AS-6280U User Guide WARNING It is the responsibility of the vehicle operator to ensure their vehicle is parked in a safe and responsible manner.
-
Page 2: Table Of Contents
Table of Contents GOVERNMENT REGULATIONS ....................... 3 INTRODUCTION WITH SMARTSTART™ ................3 VEHICLE PRESETS .......................... 4 ............................4 EATER & R & H ..................4 INDSHIELD IPERS ADIO EADLIGHTS USING THE REMOTE CONTROL ..................... 4 REMOTE STARTING YOUR VEHICLE ..................... 5 .................. -
Page 3: Government Regulations
Government regulations This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. -
Page 4: Vehicle Presets
Vehicle Presets Heater When leaving the vehicle it is recommended to preset the accessory controls in preparation for the next remote start. Settings for the blower motor (fan), front and rear, should not be left on High. It is recommended to leave the settings on Low or Medium instead. Windshield Wipers &... -
Page 5: Remote Starting Your Vehicle
Remote starting your vehicle Setting Your Vehicle into Ready Mode If your vehicle has a manual transmission you must read the following indications. The unit must first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready Mode, it cannot remote start the vehicle. -
Page 6: Remote-Starting
Remote-starting Press the button for approximately 1 second. The parking lights will turn ON to inform you that the Remote Car Starter has received your signal. Approximately 5 seconds later, the engine will start. The parking lights will remain ON during the pre-programmed run time of the engine. If your vehicle does not start at the first attempt, the system will shut down, wait a few seconds and try to start the engine again. -
Page 7: Remote Starter Features
To disarm the alarm: 1. Press the button on the transmitter. The siren will chirp twice. The LED on the antenna will remain OFF. Remote starter features Remote Door Locks If your system was installed with the Remote Door Locks option, you will have the convenience of remote keyless entry. -
Page 8: Valet Mode
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as that used for Ready Mode (page XX); at the last step, press button to lock the doors, arm the system and leave the engine running. NEW FEATURE –... -
Page 9: Panic Mode
To take the system out of Valet Mode Using the KEY (Ignition Valet Mode): Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the IGNITION/RUN and OFF positions 5 times until the parking lights flash twice. Turn the ignition OFF. -
Page 10: Extended Run Time
To exit Cold Weather Mode, do any one of the following actions: Open the hood. Start the engine remotely. Turn the ignition key to the IGNITION ON (RUN) position. Press and hold the button until the parking lights come ON for 2 seconds, pause, then flash once. -
Page 11: Advance Features: Installation Programmable Options
Immediately press the button to arm or disarm system without any chirp. Advance Features: Installation Programmable Options The system was designed with flexibility and OEM integration in mind. With its programmable options, this unit can single-handedly control nearly any electrical system in your vehicle. Note: The programming of your system should be left to a professional. -
Page 12: Safe Start
Safe Start This feature will eliminate accidental remote starts, e.g. when children are playing with the transmitter. Safe start enabled: If this feature is enabled, the user must press the button twice within 3 seconds to remote-start the vehicle. Swap start: If this feature is enabled; Press and release &... -
Page 13: Arming
Open Zone Notification (the system will warn for doors opened up to 10 seconds after arming). No Chirp (the vehicle will not chirp under any circumstance). Arming Arming of the system can be program by your installer into 4 different options. By default, your system is programmed to “passive arming –... -
Page 14: Parking Light Flash Table
Parking Light Flash Table Parking lights flashes Description Doors locked. Trunk released. Start signal received from the remote. Runtime has expired 2 slow Shutdown by remote Doors unlocked 2 fast Valet mode is deactivated 3 slow Runtime is extended. 3 fast Valet mode activated.