Related Manuals for ACTi ACM-1430 series
Summary of Contents for ACTi ACM-1430 series
-
Page 1: Quick Installation Guide
IP Outdoor IR Bullet Camera (with DC 12V / PoE / AC24V) ACM-1430 series Ver. 070709 Quick Installation Guide... -
Page 3: Getting Started
Getting Started PACKAGE CONTENTS ACM-1430 series Power Adaptor (Option) (DC12V / PoE / AC24V) Product CD Terminal Block for Power Warranty Card... -
Page 4: Physical Description
PHYSICAL DESCRIPTION Power Input If your power input is DC12V. Please follow the description on the connector to connect to power. NAME DESCRIPTION DC Power Input Ground Pin If your power input is AC24V. Please follow the description on the connector to connect to power. NAME DESCRIPTION AC Power Input... - Page 5 Audio Input / Output & Video Output The IP device supports audio input and output, and video output with terminal block. Reset Button Step 1: Switch off IP device by disconnecting the power cable Step 2: Press and continue to hold the Reset Button. Reconnect the power cable while continuing to hold the reset button.
-
Page 6: Basic Connections
BASIC CONNECTIONS Follow the procedures below to connect the IP device to the respective apparatuses. 1. Connect an analog monitor to IP device video out (BNC connector). 2. Connect the power adaptor to IP device 3. Connect IP device’s ethernet port to an Ethernet (RJ45 connectors). If your IP device has PoE built-in, you can regard it as a PD and connect it directly to a PSE device like PoE switch. -
Page 7: Installation Procedure
Installation Procedure... -
Page 8: Quick Tour
Quick Tour This section guides you with a quick tour on this IP device. 2.1 Configure this IP Device 2.1.1 Make sure network environment Default IP of this IP device is 192.168.0.100. Please make sure this IP device and your PC are on the same network segment before running the installation. Please set the settings as below. - Page 9 NOTE: If your web browser is earlier than IE6, then download IE6 is recommended. NOTE: This IP device default IP address is set to 192.168.0.100 2.1.3 Login with default administrator’s account & password NOTE: Default administrator account is set to Admin, password is set to 123456, and click button.
- Page 10 2.1.5 Set the new IP address *IP Address : The default IP address is 192.168.0.100. *Subnet Mask : The default subnet mask is 255.255.255.0 *Click button NOTE: In your Client PC, please make sure the setting of Network Connections Type is set to Auto Negotation, since this IP device follows MII standard.
- Page 11 2.1.6 Check Default Video Setting NOTE: Please make sure the TV Input (NTSC / PAL) is meet your requirement , and click button. 2.1.7 Click Save Reboot to restore all settings and please wait about 30 seconds for system reboot.